Replacing Fuel Line On Troy Bilt Weed Eater. Grasp the old fuel line inside of the tank and pull it into the tank and out the filler opening. Push one end of the line through the eyelet on the side of the outer spool, and pass it through the line loading hole on the inner spool.
Troy Bilt Trimmer Head Problems Tyres2c from tyres2c.com
The tank, the fuel lines, and the fuel filter. Ereplacementparts.com has thousands of replacement parts for a variety of power tools, outdoor. Push the end of the new fuel line through the small hole at the bottom of the tank.
The (Clear) Main Fuel Line With The Filter (Filter Inside The Fuel Tank) Goes To The Bottom Of The Carburetor (Or The Elbow Shaped Nipple).
Contains 5 refills, 100 ft. Before mixing together a new batch, check all of the components: Be sure to note on the drawing which is the small and which is the large line.
The 3 Fuel Lines Should Be Connected As Follows:
To replace a fuel filter, you need a piece of wire that you can bend at one end to make a hook. Add to cart specs & pledge specification. Cuts up to three times more area then economy lines.
To Restring A Fixed Line Head, You Grasp The Old String And Pull It Out.
There will be a rubber piece you need to remove on the outside of the weed wacker. Remove two screws, hose, and throttle cable. Pull the hose through the fuel fill hole.
Draw A Diagram Of Where The Fuel Lines Connect (Or Take A Digital Photo).
Get it as soon as tomorrow, feb 25. String comes in precut short lengths rather than on a spool. Insert the new fuel filter on the end of the fuel line.
Gently Pull Out The Hose Until The Filter, Which Is Attached To One End, Comes Out.
Thank you for your question. Leave approximately 2 inches of the hose on the outside of the tank. The tank, the fuel lines, and the fuel filter.
