Mercedes Benz Srs Light Reset. Locate the fuse panel cover and remove it. Www.vehix411.com this is the only site i use to reset my lights or to purchase parts with a 30% discount on new dealer parts.
2002 ML320 SRS Airbag Light Fix with a 25 Seat Sensor from www.benzworld.org
My srs light just came on today but that was after i removed the passenger front seat so that i could run some cables to the trunk. Low voltage can trigger the airbag / srs light as well. You’ll need a more advanced scan tool to reset the srs light.
I Took The Car This Morning To An Independent Mb Mechanic And He Was Able To Reset The Srs Light From The Connector In The Fuse Box Under The Engine Hood.
Locate the fuse panel cover and remove it. Here is some helpful info to reset srs, airbag or maintenance required lights on most vehicles. Go to the following web site:
Once The Problem Is Fixed And The Srs Module Acknowledges A Complete Circuit, The Light Will Go Off Automatically.
Or unplug for overnight if you can. How to reset mercedes srs light by autel maxidas ds808 com office blog The supplemental restraint system (srs) light in your vehicle will illuminate whenever there is a problem with your air bags or seat belt fasteners.
Didnt Have Time To Clean Up The Bottom Bracket Of The Seat Before I Had To Go To A Party So I Drove Without A Front Seat.felt Spacious Man.
The red buckle release on the driver and passenger seat. July 11, 2009 at 1:31 pm Look for a solid warning light on your dash to identify signs that one or both parts could be malfunctioning, or in need of repair.
You’ll Need A More Advanced Scan Tool To Reset The Srs Light.
No additional programming of the vin is required. There are two possible causes. This is located on the lower left side of the control panel on the driver's side of the car.
Can Cause The Airbag / Srs Light To Stay On.
If the light is on it means you have a current fault and will need a repair if it was a temporary fault the light would go off and the fault would be stored in the computor, it needs plugging in to obd computor most likely you have a faulty seat belt clip. My srs light just came on today but that was after i removed the passenger front seat so that i could run some cables to the trunk. Find the port that fits the obd cable and plug the scan tool's cable into this port.
